TRX Y-Raise
What is the TRX Y-raise, and how does it improve shoulder health and posture?
The TRX Y-Raise is a beginner-level raise movement that primarily targets the lower traps, rear delt. It uses trx as the primary implement and engages the mid-traps as secondary movers. In this guide you'll find a complete breakdown — anatomy, step-by-step setup, execution, coaching cues, common mistakes, programming recommendations, regressions, progressions, warm-up, cool-down, safety notes, and FAQs.
How to perform
-
1
Set up your trx with a weight that allows clean form for 10–12 reps.
-
2
Position your body so the lower traps, rear delt is the primary mover — brace your core before each rep.
-
3
Stack your joints — wrists under elbows, elbows under shoulders, feet hip-width for stability.
-
4
Establish a neutral spine, draw your ribs down, and breathe in to brace.
-
5
Initiate the movement with intent — control the eccentric, explode on the concentric.
Execution
-
1
Inhale and brace your core — 360° pressure into the belt line.
-
2
Lower under control (3-1-1-1 tempo) — keep tension on the target muscle.
-
3
Pause for a beat at the bottom of the range without losing brace.
-
4
Drive through the target muscle group, exhaling on the concentric.
-
5
Lock out cleanly without hyperextending — reset and brace for the next rep.
- ▸ Brace 360° around your core before every rep — never lift on a soft midsection.
- ▸ Drive through the lower traps, rear delt as the primary mover, not the joints.
- ▸ Control the eccentric for 2–3 seconds — this is where most shoulders growth happens.
- ▸ Train the longest range you can control safely — partial reps build partial strength.
- ▸ Leave 2 reps in reserve on most working sets — autoregulate when life hits hard.
- ✕ Loading the bar too heavy before owning the technique at submaximal weights.
- ✕ Cutting the range of motion short to move more weight than you can actually control.
- ✕ Letting momentum take over — bouncing, jerking, or losing brace at the bottom.
- ✕ Skipping the warm-up sets and jumping straight to working weight.
Periodisation note: Run this exercise for 4–6 weeks, then change the variation or progression. Add load when the top set feels RPE 6 — never chase numbers at the cost of form.
- Reduce load by 20–30% and slow the tempo to 4-1-2-1.
- Switch to a more stable variation: machine or supported version of the trx y-raise.
- Reduce range of motion to the pain-free portion and gradually re-expand over weeks.
- Add 2.5–5% load weekly while keeping RPE 7 on the top set.
- Increase range of motion with deficit or pause variations once you own the standard trx y-raise.
- Add a tempo or pause at the hardest position to increase time under tension.
- Tempo trx y-raise (4-2-1-0)
- Paused trx y-raise at the sticking point
- Deficit trx y-raise (increased range)
- Banded trx y-raise (accommodating resistance)
- 5 min easy aerobic work to raise tissue temperature.
- Dynamic mobility for rotator cuff activation, scapular control, thoracic mobility.
- 2 specific warm-up sets of the trx y-raise at 50% and 75% of working weight.
- 5 min easy aerobic cool-down.
- Static stretching: cross-body shoulder stretch, doorway pec stretch, child's pose.
- Breath work — 4–7–8 breathing for 5 rounds to downregulate.
- Get cleared by a physio if you have shoulder impingement, labral pathology, or AC joint irritation.
- Always use a spotter or safety pins for barbell work near 1RM loads.
- Check equipment integrity — bar collars, bench stability, clips on bands.
- Stop if you feel sharp pain in a joint. Muscle burn is fine; joint pain is not.
- Primary developer of the lower traps, rear delt.
- Reinforces the raise pattern used in daily life and sport.
- Builds strength and stability in the shoulders musculature.
- Improves movement competency under load.
- Foundational movement for almost every structured training program.
- Anyone with acute shoulder impingement, labral pathology, or AC joint irritation.
- Beginners who haven't earned the right to load the pattern yet.
- Anyone returning to training after surgery without physio clearance.
- Barbell — highest load potential, requires good mobility and stability.
- Dumbbells — greater range, less stable, good for asymmetry correction.
- Bands or machine — lower joint stress, great for rehab or burnout sets.
Research on raise movements consistently shows the lower traps, rear delt as the primary mover, with meaningful activation of the mid-traps. Time under tension in the 10–12 rep range with 60–90s rest is the sweet spot for both strength and hypertrophy adaptations.
Frequently asked questions
How often should I do the trx y-raise?
2–3x/week is a good starting point. Advanced lifters can hit shoulders 2x/week with at least 48h recovery between sessions.
Is the trx y-raise good for beginners?
Yes, if the load is conservative and technique is coached. Start with the regression listed above and progress from there.
What weight should I use for the trx y-raise?
Pick a weight that lets you complete the target reps with RPE 7–8 — that means 10–12 reps with 1–2 left in the tank. Add 2.5% when it feels easy.
Can I do the trx y-raise at home?
Yes, if you have the equipment. If not, see the equipment alternatives below for bodyweight or band-based substitutes that hit the same muscles.